Introducing the iFlight 7.5 inch long-range FPV long range drone! This beast is kitted out with a 7.5-inch carbon fiber frame and 2809 2300KV brushless motors. The 7.5-inch props give you maximum thrust and efficiency, and the 1250kv motors are powerful enough to punch through even the toughest of winds.
GPS functionality to find your way back and Betaflight GPS Rescue mode ready to setup (default OFF to prevent unexpected behaviour; Setup instructions included). Vertical and horizontal TBS Crossfire antenna mounts included to cover you and your antenna dead ends just in case. GoPro universal TPU bottom stand included; fits your original GoPro bracket and our TPU GoPro protectors (additional).
The Caddx air unit comes pre-installed. If you are using the DJI Remote, then it is bind and fly. Otherwise if you plan to use another receiver such as TBS crossfire, you will need to install this yourself (there is mounting space for this however)
Angle-Mode (self balancing level mode) is enabled by default to make sure your first flight doesn't end in a mess!
GPS Rescue is OFF by default to prevent from unwanted or unexpected drone behaviour as this is still an experimental feature. Please see our article on
how to enable GPS rescue mode
Mount pattern: 30.5*30.5mm / 4mm PCB hole diameter
Smartaudio / IRC Tramp VTX protocol supported
Firmware target: IFLIGHT_BLITZ_F722
Motor outputs: 4x (SH1.0 connector)
Flash: 32MB (Blackbox flash)
I2C serial: SDA / SLA pads
Dimensions: 36.5*35 mm
Barometer: DPS310
OSD Chip: AT7456E
LED controller: Yes
MCU: STM32 F722
Beeper pad: Yes
Gyro: BMI270
Weight: 7.8g
UARTS: 6
ESC // BLITZ E55 4-IN-1 2-6S 55A ESC
Supports: DShot DShot150/300/600/MultiShot/ OneShot etc.
Mounting Holes: 30.5*30.5mm/Φ4mm
Target: IFLIGHT_BLITZ_G2
Supports 2-6S Lipo input
Current sensor: Yes
Constant: 55 Amps
Current rate: 200
Burst: 65 Amps
Weight: 15.3g
MCU: G071
BEC: No
Included
4 x HQ 7.5X3.7X3 CW propeller + 4 x HQ 7.5X3.7X3 CCW (Color may vary)
2 x Albatross LHCP 5.8GHz SMA FPV Antenna
2 x iFlight Lipo Strap 20*250mm (Black)
1 x Pre-built and Tested Chimera7 Pro
Note:
All iFlight BNFs are tested before shipment to guarantee the highest quality.
If you still encounter a problem after receiving your shipment, please immediately contact our iFlight customer support at
www.iflightrc.freshdesk.com
.