The Motor That Stopped at Full Throttle: FPV Motor Desync and How We Prevent It

The Motor That Stopped at Full Throttle: FPV Motor Desync and How We Prevent It

How to diagnose and fix FPV motor desync when a motor stops mid-flight. Covers ESC timing, voltage sag, firmware settings, and our workshop fix checklist.

Jun 16, 2026 4 min read
How Long Do FPV Drones Last? What Our Workshop Repairs Reveal

How Long Do FPV Drones Last? What Our Workshop Repairs Reveal

How long FPV drones really last, based on what wears out in our workshop. Lifespans for motors, ESCs, batteries and props, plus what kills them...

Jun 14, 2026 4 min read
The Build We Didn't Lose in the Rain: FPV Drone Conformal Coating From Our Workshop

The Build We Didn't Lose in the Rain: FPV Drone Conformal Coating From Our Workshop

How to protect FPV drone electronics from moisture using silicone conformal coating. Covers which components to coat, application method, drying time, and UK weather considerations....

Jun 01, 2026 4 min read
The Quad That Vanished: FPV Flyaway Causes From Our Workshop Bench

The Quad That Vanished: FPV Flyaway Causes From Our Workshop Bench

Learn what causes FPV drone flyaway and how to prevent it. Covers motor order errors, board orientation, gyro drift, ESC desync, and GPS Rescue setup....

Jun 01, 2026 4 min read
The Build That Would Not Hover Straight: Why Your FPV Drone Drifts in Angle Mode

The Build That Would Not Hover Straight: Why Your FPV Drone Drifts in Angle Mode

How to fix an FPV drone that drifts in Angle or Horizon mode. Covers accelerometer calibration, board alignment, FC mounting, prop condition, centre of gravity,...

May 30, 2026 4 min read
The £12 Part That Saved £300 of Electronics: Why We Never Power On Without a Smoke Stopper

The £12 Part That Saved £300 of Electronics: Why We Never Power On Without a Smoke Stopper

Why every FPV drone build needs a smoke stopper before first power-on. Covers how PTC fuses protect against solder bridges, reversed polarity, and short circuits....

May 28, 2026 3 min read
The Noise Lines on Every First Build: FPV Power Filtering From Our Workshop

The Noise Lines on Every First Build: FPV Power Filtering From Our Workshop

How to fix horizontal lines in your FPV video feed using a low-ESR capacitor. Covers capacitor selection, soldering placement, LC filters, and testing. Workshop-tested advice...

May 27, 2026 3 min read
The Walk That Made Us Set Up Turtle Mode on Every Build

The Walk That Made Us Set Up Turtle Mode on Every Build

How to set up turtle mode on your FPV drone. Covers DShot requirements, Betaflight switch config, when NOT to use it, and workshop tips from...

May 17, 2026 4 min read
FPV Drone Not Connecting to Betaflight? The USB Fix Most Pilots Miss

FPV Drone Not Connecting to Betaflight? The USB Fix Most Pilots Miss

How to fix a flight controller that will not connect to Betaflight. Covers USB cable issues, driver installation for STM32, CP210x, and CH340 chips, DFU...

May 13, 2026 4 min read
FPV Drone Throttle Dropouts: Why Your Quad Falls Out of the Sky Mid-Flight

FPV Drone Throttle Dropouts: Why Your Quad Falls Out of the Sky Mid-Flight

How to diagnose and fix FPV drone throttle dropouts. Covers battery voltage sag, ESC overheating, connector resistance, and Betaflight settings that cause power loss mid-flight.

May 13, 2026 4 min read
FPV Drone Jello Fix: The Vibration Checklist We Run on Every Build

FPV Drone Jello Fix: The Vibration Checklist We Run on Every Build

How to fix FPV drone jello caused by vibration. Covers prop balance, camera soft mounting, motor checks, and Betaflight filter tuning from our workshop.

May 13, 2026 4 min read
We Checked 200 Crashed Drones: The Damage Checklist That Catches What Most Pilots Miss

We Checked 200 Crashed Drones: The Damage Checklist That Catches What Most Pilots Miss

How to diagnose FPV drone crash damage with a five-step checklist. Covers frame cracks, bent motors, FC checks, video system, hover testing, and LiPo safety.

May 11, 2026 4 min read