This device is designed to be powered by a maximum of 5V, any voltage that exceeds this voltage can result in permanent damage of this unit and such damage is not covered by warranty as this is operating outside specification. Please pay special attention to this.
The Walksnail Avatar Mini 1S Kit is a video transmission system designed for use in small unmanned aerial vehicles (UAVs), also known as drones. The kit includes an Avatar 1S VTX (Video Transmission) module, a nano-sized camera, and an LHCP (Left Hand Circular Polarization) antenna. The VTX module is capable of transmitting video at 1080P/60FPS, 720P/120FPS, or 720P/60FPS with an average latency of 22ms in high frame rate mode. It has a single board design and weighs only 6.8g, making it suitable for use in small drones, such as “1S whoops.” The Avatar 1S VTX also includes built-in 8GB storage, allowing it to record 1080p or 720p flight videos without interference. It is compatible with the Walksnail HD goggles or Fat Shark Dominator Avatar HD Goggles and supports BetaFlight canvas mode for OSD (On-Screen Display).
The included Avatar nano camera has a 1/2.7″ image sensor and can capture video at 1080P/60FPS, 720P/120FPS, or 720P/60FPS. It has a 170° field of view and a 2.1mm lens with an aperture of F2.0. The camera measures 14x14x17mm and weighs 3.5g, making it suitable for use in small drones. The camera is connected to the VTX module via coaxial cable.
- Low latency HD FPV footage (22ms)
- 720p/120fps or 1080p/60fps
- Full support of Betaflight OSD
- Up to 350mW power
- Lightweight design (just 6.8g air unit) with 25x25mm mounting options
- 170 degree FOV
- Internal DVR with built in 8Gb storage
- 3.1-5V input power support, ideal for Whoops.
*Range is dependent on VTX output power which is based on your country of operation to comply with local radio regulations.
Take Your 1S Whoop to the Next Level with the Walksnail Avatar Mini 1S VTX – The Ultimate HD Video Transmission Solution!
The Walksnail Avatar Mini 1S VTX is a lightweight video transmission module that is specifically designed for use in small drones, such as “1S whoops.” The term “1S” refers to the type of battery used in the drone. A “1S” battery has a single cell and a nominal voltage of 3.7V. Because the Avatar Mini 1S VTX has a wide power input range of 3.1V to 5V, it is able to work with 1S batteries and still provide stable performance.
The light weight of the VTX module is also an important factor for use in small drones, as it helps to keep the overall weight of the drone low. This is especially important for “1S whoops,” which are designed to be as lightweight and agile as possible. The VTX module’s single board design and 6.8g weight make it well-suited for use in these types of drones.
In summary, the light weight and 1S power support of the Walksnail Avatar Mini 1S VTX make it well-suited for use in small, lightweight drones, such as “1S whoops,” where weight is a critical factor in the performance and agility of the drone.
- 1x Avatar Mini 1S FPV VTX with Avatar Nano Camera and antenna