Three BECs, One Board: Why the Kakute H743 Wing Makes Sense
Learn what the Holybro Kakute H743 Wing does differently. We explain its three BEC rails, 14 ArduPilot outputs, wiring, firmware and Matek alternative.
Matek Retired the H743-SLIM. Here’s the H7A3 We’d Buy Instead
Learn whether to buy the Matek H743-SLIM V4 or newer H7A3-SLIM. Compare MCU, IMU, UARTs, PWM, logging, BECs, ArduPilot support and UK availability in detail.
The Flight Controller Lineup Nobody Can Decipher: Matek H743, F405, F722 Explained
Matek flight controller comparison covering H743, H7A3, F722, F405, F411 and G474-HELI. Specs, mounting formats, firmware support, and our picks for every build type.
Why Nobody Can Decipher the AtomRC Lineup (And Which Wing You Actually Need)
AtomRC fixed-wing FPV comparison from our workshop. Flying Fish, Penguin, Dolphin, Dolphin Pro, Swordfish and Beluga compared. Specs, configurations, and UK rules covered.
The VTOL Plane That Makes Runways Obsolete
How the ZOHD Altus VTOL eliminates hand-launching with a tri-motor tilt-rotor system. Covers PNP contents, iNav vs ArduPilot, battery choices, and build tips.
The £20 GPS Module Most Beginners Wire Wrong: BN-880 Setup
How to wire and configure the BN-880 GPS module for Pixhawk and ArduPilot. Covers pin functions, TX/RX wiring, 38400 baud setup, and compass calibration.
We Mapped 40 Acres with the Emlid Reach M2: Here Is the Exact Setup
Complete Emlid Reach M2 setup guide for drone mapping. Covers PPK and RTK modes, wiring to your flight controller, antenna placement, and Emlid Flow configuration.
We Watched Dozens of Hand-Launches Fail Before We Understood Drone Catapults
Why hand-launching fixed-wing UAVs crashes more aircraft than any other phase of flight. Covers catapult launcher setup, compatible platforms, and autolaunch integration for survey drones.
Camera Trigger Options for Drone Mapping
Learn the three main camera trigger methods for drone mapping: hot shoe, intervalometer, and flight controller software trigger. Compare accuracy, setup complexity, and use cases...
How We Got Centimetre RTK on ArduPilot with a £400 Emlid Reach M2
Learn how to integrate Emlid Reach M2 RTK GPS with ArduPilot for centimetre-level drone positioning. Covers wiring, parameter configuration, base station setup, and Mission Planner...
First Multirotor Build: Hardware to Avoid and Better Alternatives
Learn which first-build multirotor hardware to avoid from ArduPilot community experience. Covers flight controllers, frames, motors, ESCs, and GPS traps.
Holybro Sensoren für ArduPilot: Einrichtung von Airspeed, Optical Flow und Kompass
So richten Sie Holybro-Sensoren für ArduPilot ein: MS4525DO-Luftgeschwindigkeitssensor, PMW3901-Sensor für optischen Fluss und RM3100 DroneCAN-Kompass. Verkabelung und Kalibrierung.