Knowledge Base

Drone current sensors measure amp draw for accurate OSD battery readings. Learn the difference between built-in ADC sensors and external Hall effect sensors, and when...

Your FPV drone wont arm? This troubleshooting guide covers the most common reasons Betaflight and iNav block arming, from USB connections to receiver issues.

Diagnose ESC problems in FPV drones: overheating, stuttering, beeping errors, and power failures. Covers firmware settings, MOSFET testing, and when to replace.

Diagnose and fix common LiPo battery issues in FPV drones. Covers voltage sag, puffed cells, brownouts, charging faults, and storage best practices.

Diagnose and fix common FPV motor problems including motors not spinning, desync at full throttle, stuttering, and uneven thrust. Covers ESC checks, propeller issues, and...

Diagnose and fix common FPV video signal issues including static, no picture, interference, and signal breakup. Covers VTX settings, antenna problems, and frequency management.

Built-in ADC current sensors on flight controllers have 10-20% error. External Hall effect sensors offer 1-2% accuracy for reliable OSD battery monitoring.

Compare RFdesign telemetry modems: 868x, 868ux, 900x, and 900ux. Find out which long-range drone radio is right for your build.

Learn how to build a complete long-range drone data link using RFdesign telemetry modems and TXMOD for reliable control and telemetry beyond 15km.

A guide to choosing the right telemetry cable for your Pixhawk flight controller and RFdesign modem. Covers pinouts, cable types, and compatibility for RFD868x, RFD900x,...

The RFDesign TXMOD adds long-range RC control to your transmitter over 868/900MHz. Learn how it works, which radios are compatible, and what you need to...

Step-by-step guide to setting up RFdesign RFD900x and RFD868x telemetry radios with ArduPilot and PX4. Connect, configure, and test your long-range data link.