The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

SP F3 Evo Brushed Quadcopter Frame with FC, PDB built in

$25.37
SKU:
00B-9B9-37F
Shipping:
Calculated at Checkout
SP F3 Evo Brushed Flight controller quadcopter frame

This is a micro FPV quadcopter frame that has an integrated SP F3 Evo flight controller.   In addition there is also a 1-2S PDB built in to make connecting your equipment such as your R/C receiver, motors, and FPV camera neat and tidy.   The PDB includes a regulator to output 5V for your receiver/FPV camera, while having direct connectors for your motors on each arm. The frame itself weighs just 8.8g, and has support for SBUS, PPM or Spektrum receivers.  This kit includes a bunch of cables to connect your battery, and R/C receivers.  Rubber grommets are included to snugly fit your  7520-8520 Brush Motors (sold separately).

Key Features

  • Integrated quadcopter frame with SP F3 Evo brushed flight controller
  • Support 1-2S Lipo
  • Direct connectors for SPEKTRUM (DSM2/X), PPM, SBUS reeivers (with internal SBUS inverter for Frsky)
  • 4x Integrated brushed 10A ESC (4 current NMOSFET with free-wheeling diode)
  • Buzzer included, this can be used as a low voltage alarm
  • STM32 F303CCT6 MCU and MPU6500 of InvenSense Gyro. 
  • Supported by both Cleanflight and Betaflight
  • Includes 4x LED and has support for RGB LED strip.

pinout.jpg

Suggested Setup

  • Motor: 7520-8520 Brush Motor
  • Propeller Size: 55mm
  • Camera: 520TVL HD CMOS 1/4 inch Camera
  • AV Wireless Transmitter: 5.8g 25mw 32ch
  • Batterry: 3.7V 600mah 25C Lipo battery
  • Flight time: 5-6 minutes
  • Camera: 520TVL HD CMOS 1/4 inch Camera
  • Video Output format: PAL / NTSC
  • AV Wireless Transmitter: 5.8g 25mw 32ch
  • Batterry: 3.7V 600mah Lipo battery