Features
Specifications
Flight Controller
-
MCU: STM32F722RGT6 216MHz
-
Gyroscope: BMI270
-
Baro:Bmp280
-
OSD: Betaflight SPI OSD DJI HD OSD(UART6)
-
Black box: 16MB
-
6x Uarts: UART 1/2/3/4/5/6
-
4x PWM outputs
-
1x I2C
-
3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
-
USB Type-C(USB2.0)
-
1x JST-SH1.0_8pin connector (Gnd/Vbat/S1/S2/S3/S4/Rx3/Curr)
-
1x JST-SH1.0_6pin connector (R1/G/R6/T6/G/10V)
-
VTX 10V/Vbat filtered power ON/OFF switch
-
DJI FPV OSD is supported by any spare UART
-
LED: 4 LED independent pads, support WS2812 programming lamp output.
-
Receiver: Support Sbus, crsf, ibus, SBUS, XBUS, support 3.3v Spektrum satellite receiver, The default receiver input is UART1(You can solder ELRS RX on UART1), F7 has a built-in inverter, which can be installed in any spare UART.
- Input voltage: 3-6S
- BEC: 5V/10V 3A max dual-channel BEC supports stable power supply on the sky side of DJI
- LDO 3.3V: Max.250mA
- BetaFlight firmware: SKYSTARSF722Pro
- INAV firmware: SKYSTARSF722HD
- Installation size: 30.5mm × 30.5mm The installation hole is M4 and supports shock column installation
- External size 39mm × 39mm
- Flight control weight: 6.9g
- Flight control onboard voltage sensor.
- Support 128K Dshot1200, Dshot600, Dshot300, Dshot150, Oneshot125, Multishot, PWM control signal
- Power supply voltage: 3-6S (12-26V)
- Continuous working current: 45A 60A
- No built-in 5V BEC output
- Firmware: BLHELI 32 ESC
- Screw hole spacing: 30.5*30.5MM
- Aperture: 4MM
- Weight: 14.6g
Includes
-
1x F7HD Pro3 FC
-
1x KO45 or KO60 128K BL32 4IN1 ESC
-
8x Silicon grommets M4 to M3
-
2x JST-SH1.0_8pin cable, 4cm
-
1x JST-GH-6P cable for DJI port, 10cm
Reviews
There are no reviews yet.