This is the F3 V.10 brushed flight controller with an integrated OSD that is compatible with BetaFlight from Realacc. This is a great little brushed flight controller that runs the STM32 F303 CCT6 processor and measures just 20x28mm. This is perfect for your brushed project!
- Size: 20mm*28mm
- Weight: 2.2g
- Processor: STM32 F303 CCT6
- Sensor: MPU6000
- Firmware Version: Betaflight_3.0.1_OMNIBUS
- Power supply: MAX 4.2V (1S) Lipo Battery
- SBUS/PPM/DSM input
- LED strip solder pin
- Buzzer solder pin
- OSD pin (camera input, 5.8G FPV output)
- USB interface (on-line parameter tuning)
- Built-in OSD (using F3 MCU controls OSD over SPI bus in DMA mode)
- Built-in step-up voltage power module, output 5V 500MA.
- With 4 large current NMOS transistors, operating current of up to 10A each
1. SBUS and DSM receiver input, please configure RX3 as input interface.
2. DSM receiver power from 3.3V.
3. SBUS and PPM receiver power from 5V.
- 1 x Realacc F3 Brushed Flight Controller Board
- 1 x power cable
- 1 x mounting pad
- 1 x buzzer