Not the cheapest?
Let us know, we will try to beat it!
Mechaduino Compatible Nema 17 Two Phase Servo Stepper Motor
£34.95 (ex VAT £29.13)
In stock
Mechaduino is a self-contained motion control platform which allows you to develop your own custom servo mechanisms. It can be also be used as a drop-in servo motor for 3D printers and CNC machines. No more missed steps! This product includes a Nema 23 42 stepper motor coupled with a Mechaduino controller. Available with a selection of shafts for your specific mechatronics application.
Not the cheapest?
We will try to beat it!
⚠️Always test your item before soldering, issues caused by soldering aren't covered by warranty.
Mechaduino-Manual
Specifications
- Product Name: 42 two-phase stepper motor
- Model number :17HS4401
- Step angle : 1.8 °
- Maximum no-load starting frequency : ≥ 1400 PPS
- Rated voltage 3.6V
- Maximum no-load operating frequency : ≥ 4000 PPS
- Rated current : 1.5A / phase
- Phase inductance :3.7 × (1 + 20%) mH
- Holding torque : ≥420 mN.m
- Phase resistance : 2.4 × (1 + 15%) Ω / phase
- Positioning torque : 15 mN.m REF
- Electric strength : AC600V / 1mA / 1S
Wiring Guide
1. VCC : Connect 12-30V power supply ( Refer to the working voltage of the motor, general 24V )
2. GND: Ground wire
3. CLK : Control signal (Connected to pulse input )
4. DIR: Direction control signal ( Floating forward, ground reverse )
5. ENA: Connect to enable signal ( Default enable, grounding stops working )
6. P2: Connect one phase to the motor on each side ( Refer to the motor parameter description, the motor is divided into two phases AB, pins 1 and 2 are connected to one phase, and pins 3 and 4 are connected to the other phase. )
DIP Switch Operation
DIP switch {ON (1) / OFF (0)}:
- Div1, Div2 control pulse frequency division
(1) 00: 4 subdivision
(2) 10: 8 subdivision
(3) 01:16 subdivision
(4) 11:32 subdivision
- Ctl setting control mode, open-loop / closed-loop
(1) 0 : Open-loop mode
(2) 1 : Closed-loop mode
- AC setting calibration
Turn the AC to position 1, and turn on the power. The LED blinks 3 times to start automatic calibration. The motor shaft rotates counterclockwise for one cycle and then clockwise for one cycle. The system automatic calibration complete and the LED continues to flash. The AC dial returns to position 0, and then restart power.
Kit Contents
- 1 x Stepper motor with Mechaduino control board
- 1 x 6P Connection cable
| Weight | 750 g |
|---|---|
| Dimensions | 10 × 10 × 10 cm |
Only logged in customers who have purchased this product may leave a review.
Share this item on:
Product Meta Information:
Reviews
There are no reviews yet.