Get ready to fly like a pro with the XRotor F7 Convertible Flight Controller from Hobbywing! This bad boy is packed with super hardware and lightning fast running speed, thanks to its STM32F722 MCU and high sensitivity ICM20602 six-axis motion sensor. Plus, it’s fully equipped to support bidirectional DShot digital throttle communication.
But that’s not all, this flight controller also comes with a special interface for the DJI image transmission system, allowing for seamless plug-and-play action. And let’s not forget about the on-board 5V & 12V dual BEC circuit, which will give you the power to run all your image transmission and 12V LED devices.
And the XRotor F7 doesn’t just support one type of firmware, oh no. It supports BetaFlight, Cleanflight, Butterflight, iNav, and other mainstream FPV firmware, so you can customize your flying experience to your exact specifications. Plus, it’s designed with a unique installation design and shock absorption structure, making it more stable and accurate in flight.
It’s also a perfect match for Hobbywing ESC and has volt/amp monitoring port, buzzer output port, Micro USB port, switch module of board load graphic transmission and double M3 mounting holes with damping aprons making it even more convenient to use.
Upgrade your flying game with the XRotor F7 Convertible Flight Controller from Hobbywing!
Features
- Equipped with STM32F722 MCU which has powerful computing ability and fast running speed, and high sensitivity ICM20602 six-axis motion sensor.
- Supports BetaFlight, Cleanflight, Butterflight, Inva, and other mainstream FPV firmware.
- DJI image transmission system port equipped with corresponding flat cable
- Supports bidirectional DShot digital throttle communication.
- Unique installation design and shock absorption structure.
- On-board large capacity Flash memory chip.
- On-board 5V & 12V dual BEC circuit.
- On-board Pit Switch module.
Specifications
- Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc
- Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL
- Mounting Holes: Convertible 20x20mm / 30.5×30.5mm
- Programming via: Betaflight/Cleanflight-configurator
- Firmware: HOBBYWING_XROTORF7CONV
- Voltage Monitoring: Supported
- Current Monitoring: Supported
- FC Programming: Supported
- External Buzzer: Supported
- BEC: 5V@1.5: 10V@1.5A
- LED Control: Supported
- USB Port: MicroUSB
- Size: 32x32mm
- OSD: Built-in
- Weight: 3.3g
Manual
Includes
- 1x Hobbywing XRotor F7 Convertible Flight Controller
- 1x Soft Mounting Grommets Set
- 1x Signal Cable