Not the cheapest?

Let us know, we will try to beat it!

Coupons PRICE MATCH

⚠️Check Before Soldering

If you need to solder or make any modifications to your item please test the item first. Modification or problematic soldering can cause damage not covered under warranty.

Share This Item:

Happymodel Moblite7 Ultralight Whoop Quadcopter

(1 customer review)

£87.39

SKU: MOBLITE7 Category: Tags: , , Brand:

Inspired by Mr Shutterbug, this is an ultra lightweight whoop (36g with a 650mah lipo), that has incredible performance with longer flight times compared to the standard whoops.

Happymodel Moblite7 Ultralight Whoop Quadcopter

£87.39

Inspired by Mr Shutterbug, this is an ultra lightweight whoop (36g with a 650mah lipo), that has incredible performance with longer flight times compared to the standard whoops.

Not the cheapest?

We will try to beat it!

⚠️Always test your item before soldering, issues caused by soldering aren't covered by warranty.

SKU: MOBLITE7 Category: Tags: , , Brand:

Features

  • The lightest 1s 75mm brushless whoop
  • Powerful and efficient
  • The lightest 1s AIO 5IN1 F4 flight controller
  • New Unibell EX0802 brushless motors
  • Low profile Canopy design
  • VTX power switchable 25mw~200mw

MobLite6 & MobLite 7 // The efficient Mobula Whoop // Long Flight Time // Low Profile

Specifications

  • Brand Name: Happymodel
  • Item Name: Moblite7 1S 75mm ultra light brushless whoop
  • Wheelbase: 75mm
  • Size: 97mm*97mm*25mm
  • Weight: 19.5g (without battery)
  • Weight:36g(with Original 1s 650mah Lipo battery )
Motor Mode: EX0802 19000KV
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
Weight(g):1.7g
No.of Cells(Lipo):1S only
Flight controller (Frsky SPI RX version) DiamondF4 FR FC Firmware target: CrazybeeF4FR
(Flysky SPI RX version)DiamondF4 FS FC Firmware target: CrazybeeF4FS
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Original whoop size compatible
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky/Flysky receiver
Built-in 5V 1A BEC
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_50_REV16_8.HEX
Default protocol: DSHOT600
Onboard Frsky SPI D8 receiver Version SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 modelChannels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m
Onboard Flysky SPI receiver Version SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 200~300m
Failsafe support
Onboard 5.8g VTX Output power: 25mw~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels(include Race band)Smartaudio ready
Runcam Nano 3 Model: RunCam Nano 3
Image Sensor: 1/3″ CMOS
Horizontal Resolution: 800TVL
Lens : 2.3mm(M6.5) FOV 140°
Signal System: PAL/NTSC Non Switchable
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: 0.01Lux@1.2F
D-WDR: Auto
Day/Night: Color
Power:DC 3-5.5V
Current: 110mA@5V 120mA@3.3V
Housing Material: ABS
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm
Lipo Battery Capacity:650mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Instantaneous discharge rate: 60C
Size: 60mmx18mmx8mm
Weight: 16g
Connector: PH2.0

Included

  • 1 x Happymodel Moblite7 75mm Whoop RC FPV Racing Drone
    • Option1: 1 x DiamondF4 FR built-in SPI Frsky Receiver
    • Option2: 1 x DiamondF4 FS built-in SPI Flysky Receiver
  • 4 x EX0802 KV19000 Unibell Brushless Motor
  • 1 x HQPROP 40MMX2 Propeller(4cw+4ccw)
  • 1 x Runcam Nano 3 FPV Camera
  • 1 x Built-in 5.8G 40ch 25mw-200mw VTX
  • 2 x 1S 650mah Lipo Battery
  • 1 x Propeller Disassemble Tool
  • 1 x Screwdriver
  • 1 x Happymodel Carry Case

 

Weight 200 g
Dimensions 10 × 10 × 5 cm
Receiver

,

KV Rating

1 review for Happymodel Moblite7 Ultralight Whoop Quadcopter

  1. Jason (verified owner)

    A mixed bag of a whoop. Good thing you get a screwdriver and a spare frame in the box as mine was heavily bent out of shape. I had to swap the frame straight away it was that bad. The camera mounting system is what it is – its ok as long as you make sure you check the cams alignment before every flight. The best part of the whole kit is the FC board with everything built in. Leaving on a positive note – flying at a generous pace round the in-house track ( over 2 floors ) – the included 650mah lipos got me an amazing 11m 30s !!!

Only logged in customers who have purchased this product may leave a review.

Share this item on:

Product Meta Information:

SKU: MOBLITE7 Category: Tags: , , Brand:

Features

  • The lightest 1s 75mm brushless whoop
  • Powerful and efficient
  • The lightest 1s AIO 5IN1 F4 flight controller
  • New Unibell EX0802 brushless motors
  • Low profile Canopy design
  • VTX power switchable 25mw~200mw

MobLite6 & MobLite 7 // The efficient Mobula Whoop // Long Flight Time // Low Profile

Specifications

  • Brand Name: Happymodel
  • Item Name: Moblite7 1S 75mm ultra light brushless whoop
  • Wheelbase: 75mm
  • Size: 97mm*97mm*25mm
  • Weight: 19.5g (without battery)
  • Weight:36g(with Original 1s 650mah Lipo battery )
Motor Mode: EX0802 19000KV
Configu-ration:9N12P
Stator Diamter:8mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ10.5mm*14.9mm
Weight(g):1.7g
No.of Cells(Lipo):1S only
Flight controller (Frsky SPI RX version) DiamondF4 FR FC Firmware target: CrazybeeF4FR
(Flysky SPI RX version)DiamondF4 FS FC Firmware target: CrazybeeF4FS
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Original whoop size compatible
Power supply: 1S battery input (DC 2.9V-4.35V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Built-in Betaflight OSD(SPI Control)
Built-in 5.8G VTX
Built-in SPI Frsky/Flysky receiver
Built-in 5V 1A BEC
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1S LiPo/LiPo HVCurrent: 5A continuous peak 6A (3 seconds)
Support BLHeliSuite programmable
Factory firmware: O_H_50_REV16_8.HEX
Default protocol: DSHOT600
Onboard Frsky SPI D8 receiver Version SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 modelChannels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 200m~300m
Onboard Flysky SPI receiver Version SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 200~300m
Failsafe support
Onboard 5.8g VTX Output power: 25mw~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Frequency: 5.8GHz 5bands 40 channels(include Race band)Smartaudio ready
Runcam Nano 3 Model: RunCam Nano 3
Image Sensor: 1/3″ CMOS
Horizontal Resolution: 800TVL
Lens : 2.3mm(M6.5) FOV 140°
Signal System: PAL/NTSC Non Switchable
S/N Ratio: >50dB
Electronic Shutter Speed: Auto
Auto Gain Control (AGC): Auto
Min. Illumination: 0.01Lux@1.2F
D-WDR: Auto
Day/Night: Color
Power:DC 3-5.5V
Current: 110mA@5V 120mA@3.3V
Housing Material: ABS
Net Weight: 1.2g
Dimensions: L14mm*W14mm*H9mm
Lipo Battery Capacity:650mAh
Voltage:3.8v
Continuous Discharge Rate: 30C
Instantaneous discharge rate: 60C
Size: 60mmx18mmx8mm
Weight: 16g
Connector: PH2.0

Included

  • 1 x Happymodel Moblite7 75mm Whoop RC FPV Racing Drone
    • Option1: 1 x DiamondF4 FR built-in SPI Frsky Receiver
    • Option2: 1 x DiamondF4 FS built-in SPI Flysky Receiver
  • 4 x EX0802 KV19000 Unibell Brushless Motor
  • 1 x HQPROP 40MMX2 Propeller(4cw+4ccw)
  • 1 x Runcam Nano 3 FPV Camera
  • 1 x Built-in 5.8G 40ch 25mw-200mw VTX
  • 2 x 1S 650mah Lipo Battery
  • 1 x Propeller Disassemble Tool
  • 1 x Screwdriver
  • 1 x Happymodel Carry Case

 

Weight 200 g
Dimensions 10 × 10 × 5 cm
Receiver

,

KV Rating

1 review for Happymodel Moblite7 Ultralight Whoop Quadcopter

  1. Jason (verified owner)

    A mixed bag of a whoop. Good thing you get a screwdriver and a spare frame in the box as mine was heavily bent out of shape. I had to swap the frame straight away it was that bad. The camera mounting system is what it is – its ok as long as you make sure you check the cams alignment before every flight. The best part of the whole kit is the FC board with everything built in. Leaving on a positive note – flying at a generous pace round the in-house track ( over 2 floors ) – the included 650mah lipos got me an amazing 11m 30s !!!

Only logged in customers who have purchased this product may leave a review.

Happymodel Moblite7 Ultralight Whoop Quadcopter
£87.39 Select options