FSD Nano V2 Receiver (FRsky / DSMX)

Features

• Tiny Receiver (0.8g) (15x10mm)
• Available as either Frsky D8 or DSMX Compatible
• 300m+ Range
• Replaceable antenna

Specification

• Brand name: full speed
• Name: Nano V2
• Voltage: 5V
• Weight: 0.8 grams
• Signal System: Frsky D8 Mode / DSMX (DSM2) depending on which version you select
• Frequency band: 2.4GHz
• Range: 300M+
• Size: 14.5mm x 10.5mm x 2.5mm

Binding (DSMX)

1. Connect the receiver to FC and run the BF. Choose the correct port and type of your receiver on the flight controller.
   2. Type: set spektrum_sat_bind=9 in CLI then type ‘ save’.
2. Disconnect the power and repower. The light on the receiver will flash quickly which means it’s on binding mode.
3. Turn on the radio and select bind mode. Wait a moment, It means bind successfully if the light on receiver stays on.
4. After binding. Type: set spektrum_sat_bind=0 and type ‘save’ to quit the binding mode.

DSMX Pinout

Binding (Frsky)

Matching frequency method:
1. Select D8 mode on Frsky remote control. Hold the bind key on Frsky-Nano receiver and connect the battery, then the receiver’s red light will be always on.
2. Select the BIND  mode  on remote control , the Frsky Nano receiver’s blue light will flash slowly and the red light will be always on which means bind complete.
3.Enter: set sbus_inversion = off (set serialrx_inverted = on if your F3 FC is BF3.3 or newer)on BF CLI and save.
4. Repower the Frsky-Nano receiver . The red light on it will flash very quickly which means it receives the singal from remote control.

Frsky pinout

Notice：
The receiver defaults to the BUS protocol (The non-invert signal). When using F3 and F7 flight controller, it can be switched to SBUS protocol (The invert signal) by entering the command in BF CLI (step 3 of the binding tutorial). When using F4 flight controller (F4 flight controller does not support to switch signal type by entering command on CLI), if there isn’t respond in BF receiver page when the receiver binding with remote controller successfully, please press the binding button to switch the signal protocol after the receiver  power on. After short pressing the binding button, the red or blue light on receiver will flash 3 times. Blue light flashes 3 times means the receiver is on BUS protocol (original default setting), the red light flashes 3 times means the receiver is on SBUS protocol (which can be supported on most of F4 flight control).Please re-power the receiver after switching the protocol then the red/blue light on receiver will flash 3 times to show the current protocol.

Included

• FullSpeed Nano RX
• 2.4Ghz Antenna