This is the F4 flight controller with an in-built VTX and OSD as featured in the Eachine Stack-X F4 Flight Stack. This flight controller weighs just 7g and can support between 2-6S power input.
This flight controller comes with two antenna and screw pack for installation.
- STM32F405 MCU Runs Betaflight 3.2.0 firmware.
- Use ICM-20608 as Acc & Gyro over SPI Bus.
- Serial or PPM signal input.
- STM32 control Betalfight OSD Over SPI in DMA Mode– configure by Betaflight GUI.
- Integrated 5.8G 48CH VTX power switchable – 50mw / 200mw switchable.
- STM32 control VTX Band / Channel / Power -Set in Betaflight GUI in CLI Command.
Have a look at the Eachine Stack-X F4 Flight Stack manuals for all the information.