KOPIS is a high-performance ready built FPV racing drone from Holybro, Low-deck design means centralized mass and excellent handling. Stretched-X motor layout is the choice of top racers because the rear props are further from the "dirty air" coming from the front props. The result is smoother cornering and higher top speed. The FPV antenna is in a unique location behind the quad, to protect against damage. Kakute F7 flight controller and Atlatl HV V2 video transmitter give perfectly integrated control of all quadcopter systems. TMOTOR F40 Pro-II 2400kv motors give awesome power and speed, just like top racers. RunCam Swift Micro camera is light and small, with great image quality. KOPIS gives all the performance, looks, and durability of a hand-built machine, without ever having to pick up a soldering iron! (assuming you are using an XSR receiver)
- 5mm full 3k carbon fiber twill
- Counter-sunk screws on base for great appearance and protection of battery against damage.
- KakuteF7 flight controller with soft-mounted gyro for mechanical filtering of vibration. Means you can disable more software filters for best flight handling.
- Improved soft-mounting foam for KakuteF7 gives optimal balance of stiffness and damping for even better gyro performance than before!
- Betaflight OSD included. Monitor voltage and battery capacity in your FPV goggles. Change PIDs and Rates using your transmitter sticks.
- Atlatl HV V2 video transmitter:
- 5.8 GHz o Standard 40-channel set. However 5645 MHz and 5925 MHz 5945 MHz are illegal in many areas, so they are not supported. If you select one of these channels, it will simply fail to work.
- Output Power: 0.5 mW (pit mode), 25 mW, 200 mW, 500 mW, 800 mW o MMCX antenna connector for easy, secure connection. Won’t break or come loose like the IPEX connector used on other vTX.
- Control the vTX channel and transmit power from the OSD using your transmitter sticks or from your Transmitter. No more picking up the quad to change vTX settings!
- Buzzer included.
- RunCam Swift Micro FPV camera
- Adjustable camera uptilt from 0 degrees to 90 degrees.
- Serial receiver supported (SBUS, iBUS, Spektrum). Legacy PPM and PWM receivers not supported.
- MCU: STM32F745VGT6 32-bit processor
- IMU: ICM20689 (SPI) 32 kHz capable
- Barometer: BMP280
- TF card for Blackbox logging
- Tekko32 BLHeli_32 4-in-1 ESC (Dshot1200 compatible)
- Supports 4S-6S battery (motors are optimized for 4S)
- Weight 299 grams without battery or props
- R/C Receiver (Frsky XSR recommended as it plugs in without any soldering) but you can also use any other serial receiver.
- 1500-1800 4S Lipo (at least 75C)
- Some time to setup the quadcopter per your flight preferences