The cookie settings on this website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site.

F3 Evo Brushed Flight Controller (1s/2s)

$20.35
SKU:
SKU454876
UPC:
1.91E+11
Shipping:
Calculated at Checkout
Bulk Pricing:
Buy in bulk and save
F3 Evo Brushed Flight Controller (1s/2s)

Out of stock

The F3 Evo brushed flight controller is based of the popular SP F3 Evo flight controller design, but includes some extra electronics to allow you to use this board with coreless brushed motors for a nano quadcopter build.  This flight controller is fully compatible with cleanflight.  This flight controller supports both 1s or 2s batteries (via a solder jumper).  This flight controller uses the 32bit STM32F303CT6 micro controller with an MPU6500 IMU for impressive performance for your brushed nanoquad.  The built in motor controllers can handle up to 10A allowing you to use beefy coreless motors with this flight controller.  

Key Features

  • 32bit brushed flight controller based on SP RACING F3  firmware (cleanflight compatible).
  • The flight control supports 1S (4.2V) and 2S (8.4V) power supply via solder jumper selecter (see below).
  • Independent design of the circuit structure, comes with the pressure reduction technology, whether it is 1S or 2S power input, UART1/2 output 5V, UART3 output 3.3V
  • Using STM32F303CCT6 + MPU6500, advanced hardware platform F3 guarantee more stable flight
  • With a large current NMOS transistors, operating current of up to 10A or more. Each machine is equipped with freewheeling diodes.
  • Support for PPM, SBUS, DSM receiver input signal.
  • With battery voltage detection and buzzer interface.
  • Wide range of coreless motor support including sizes up to 1020.

Pinout Diagram

f3-evo-brushed-pinout.jpeg

Power supply selection

f3-brushed-top2.jpg

By default the F3 Brushled flight controller is configured to be powered via a 1S power supply, however if you want to use 2S supply you just need to change the solder jumper on the top of the board according to the image above.  If you are not sure please contact us before trying this to avoid any damage to your board.  Make sure that you do not short all three pads, otherwise you will fry your board immediately.

Selecting DSM/SBUS/PPM

  • To select DSM receiver simply use the DSM connector directly on the board (next to the arrow) (3.3V, GND, RX3) - this will use the UART3 port
  • To use SBUS reciever connect it directly to the UART2 connector (GND, 5V, RX2) and setup the UART2 port within cleanflight for serial RX.
  • To use PPM, connect your receiver directly to the UART2 port (GND, 5V, RX2) and select PPM as the receiver mode within cleanflight.
 -->